FRONT SEAT OUTER BELT ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE FRONT DOOR SCUFF PLATE

    Click here

  4. REMOVE REAR STEP COVER

    Click here

  5. REMOVE REAR DOOR SCUFF PLATE

    Click here

  6. REMOVE CENTER PILLAR GARNISH COVER

    Click here

  7. REMOVE CENTER LOWER PILLAR GARNISH

    B001Y3K

    Tech Tips


    • for Manual Seat:

      When removing the center pillar garnish cover, move the front seat and seatback to the foremost upright position.

    • for Power Seat:

      When removing the center pillar garnish cover, connect the cable to the negative (-) battery terminal and operate the power seat switch to move the front seat and seatback to the foremost upright position. After moving the front seat, disconnect the cable from the negative (-) battery terminal.


    1. Remove the bolt and seat belt anchor.

    2. B001Z8X

      Detach the 2 claws and 7 clips, and remove the center lower pillar garnish.

  8. REMOVE REAR ASSIST GRIP ASSEMBLY

    Click here

  9. REMOVE CENTER PILLAR GARNISH

    Click here

  10. REMOVE FRONT SEAT OUTER BELT ASSEMBLY

    B001YF1

    1. Remove the nut and shoulder anchor.

    2. B001ZTVE01

      Disconnect the pretensioner connector labeled A as shown in the illustration.

    3. Disconnect the tension reducer connector labeled B.

    4. w/ Pre-Crash Safety System:

      Disconnect the pre-crash safety connector labeled C.

    5. B001XBB

      Remove the bolt and seat belt.

  11. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY

    B001X07

    1. Remove the 2 bolts and adjuster.