SEAT BELT WARNING SYSTEM DATA LIST / ACTIVE TEST


  1. READ DATA LIST

    Note

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    Tech Tips

    Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Body / (desired system) / Data List.

    5. According to the display on the GTS, read the Data List.

      Combination Meter
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      P-Seatbelt Buckle SW Front passenger side seat belt buckle signal / ON or OFF

      ON: Front passenger side seat belt is fastened

      OFF: Front passenger side seat belt is unfastened

      		 -
      Passenger Occupant Detection Switch Occupant detection sensor signal / ON or OFF

      ON: Front passenger seat occupied

      OFF: Front passenger seat not occupied

      		 -
      D - Seatbelt Warning Buzzer* Driver side seat belt warning signal / ON or OFF

      ON: Driver side seat belt warning buzzer is sound

      OFF: Driver side seat belt warning buzzer is not sound

      		 The current customize setting is displayed.
      P - Seatbelt Warning Buzzer* Front passenger side seat belt warning signal / ON or OFF

      ON: Front passenger side seat belt warning buzzer is sound

      OFF: Front passenger side seat belt warning buzzer is not sound

      		 The current customize setting is displayed.

      *: w/ Seat Belt Warning Buzzer

      SRS Airbag
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Driver Buckle SW Driver side seat belt / Set, Unset or NG

      Set: Driver side seat belt is fastened

      Unset: Driver side seat belt is unfastened

      		 NG: Data is not determined

  2. PERFORM ACTIVE TEST

    Tech Tips

    Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Body / Combination Meter / Active Test.

    5. According to display on the GTS, perform the Active Test.

      Combination Meter
      Tester Display Test Part Control Range Diagnostic Note
      Driver Side Seat Belt Driver side seat belt warning light ON/OFF -
      Front Passenger Side Seat Belt Front passenger side seat belt warning light ON/OFF -