REAR NO. 1 SEAT OUTER BELT ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)

    Click here

  4. REMOVE REAR NO. 2 SEAT ASSEMBLY (w/ Rear No. 2 Seat)


    1. Remove the rear No. 2 seat assembly Click here.

  5. REMOVE REAR FLOOR MAT REAR SUPPORT PLATE

    Click here

  6. REMOVE REAR STEP COVER

    Click here

  7. REMOVE REAR DOOR SCUFF PLATE LH

    Click here

  8. REMOVE NO. 1 TONNEAU COVER HOLDER CAP (w/ Tonneau Cover)

    Click here

  9. REMOVE REAR NO. 2 SEAT COVER BEZEL (w/ Rear No. 2 Seat)

    Click here

  10. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY LH

    B001XME
    B001Z6R

    Tech Tips

    When removing the front quarter trim panel, operate the reclining adjuster release handle and move the No. 1 rear seat to the position shown in the illustration.


    1. Detach the 3 claws and remove the cover.

    2. B001YLX

      Remove the bolt and disconnect the rear seat outer belt floor anchor.

    3. B001XHX

      w/ Rear No. 2 Seat, for LH side:


      1. Remove the bolt and disconnect the rear No. 2 seat outer belt floor anchor LH.

    4. B001W3C

      w/ Rear No. 2 Seat, for RH side:


      1. Detach the 3 claws and remove the cover.

      2. B00201O

        Remove the bolt and disconnect the rear No. 2 seat outer belt floor anchor RH.

    5. w/o Tonneau Cover:


      1. Remove the clip and bolt.

      2. Detach the 18 clips and 2 claws.

      3. w/o Rear Air Conditioning System:

        Disconnect the rear seat lock control lever cable and then remove the quarter trim panel.

      4. w/ Rear Air Conditioning System:

        Disconnect the thermistor connector and rear seat lock control lever cable, and then remove the quarter trim panel.

        B001WZM

    6. w/ Tonneau Cover:


      1. Remove the screw and clip.

      2. Detach the 18 clips and 2 claws, and remove the quarter trim panel.

        B001ZG2

  11. REMOVE REAR FRONT QUARTER TRIM GARNISH LH

    Click here

  12. REMOVE REAR NO. 1 SEAT OUTER BELT ASSEMBLY LH

    B001Z7X

    1. Remove the nut and seat belt shoulder anchor.

    2. B001YOT

      w/ Pretensioner:

      Disconnect the pretensioner connector as shown in the illustration.

    3. B001XUU

      Remove the 2 bolts and rear No. 1 seat outer belt.

  13. REMOVE REAR SHOULDER BELT ANCHOR PLATE SUB-ASSEMBLY LH

    B001YUE

    1. Remove the 2 bolts and anchor plate.