LUMBAR SUPPORT ADJUSTER ASSEMBLY(for Manual Seat) REMOVAL

CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. REMOVE FRONT SEAT ASSEMBLY LH


    1. Remove the front seat assembly Click here.

  2. REMOVE VERTICAL ADJUSTER COVER LH (for 8 Way Seat Type)

    Click here

  3. REMOVE VERTICAL ADJUSTING HANDLE LH (for 8 Way Seat Type)

    Click here

  4. REMOVE VERTICAL SEAT ADJUSTER KNOB (for 8 Way Seat Type)

    Click here

  5. REMOVE RECLINING ADJUSTER RELEASE HANDLE LH

    Click here

  6. REMOVE FRONT SEAT CUSHION SHIELD LH

    Click here

  7. REMOVE FRONT SEAT INNER BELT ASSEMBLY LH

    Click here

  8. REMOVE FRONT INNER SEAT CUSHION SHIELD LH

    Click here

  9. REMOVE FRONT SEATBACK BOARD SUB-ASSEMBLY LH (w/ Seatback Board)

    Click here

  10. REMOVE FRONT SEAT HEADREST SUPPORT (w/ Active Headrest)

    Click here

  11. REMOVE SEATBACK COVER WITH PAD

    Click here

  12. REMOVE LUMBAR SUPPORT ADJUSTER ASSEMBLY LH (w/ Lumbar Support)


    1. A01XA4SE02
      *1 Cable Clamp

      Remove the 4 springs.

    2. Remove the cable clamp and disconnect the active headrest cable from the seatback spring.

    3. Detach the 4 hooks and remove the seatback spring.

    4. A01X54G

      Disconnect the lumbar support adjuster connector.

    5. Remove the 2 screws and lumbar support adjuster.