REAR NO. 1 SEAT ASSEMBLY(for 60/40 Split Seat Type 40 Side) DISASSEMBLY

CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. REMOVE SEAT ADJUSTER BOLT COVER

    A01XAAK

    1. Using a screwdriver, detach the 2 claws and remove the cover.

      Tech Tips

      Tape the screwdriver tip before use.

  2. REMOVE RECLINING ADJUSTER RELEASE HANDLE RH

    A01X9A7

    1. Remove the screw and release handle.

  3. REMOVE REAR NO. 1 SEAT RECLINING COVER RH

    B0010WEE01

    1. Remove the 2 screws.

    2. Detach the 3 claws in the order shown in the illustration, and then remove the cover.

  4. REMOVE REAR NO. 1 SEAT RECLINING COVER LH

    A01XAFO

    1. Remove the 2 screws.

    2. Detach the 4 claws and remove the cover.

  5. REMOVE UPPER SEAT TRACK RAIL COVER LH

    A01X7X7

    1. Using a screwdriver, detach the 2 claws and remove the cover.

      Tech Tips

      Tape the screwdriver tip before use.

  6. REMOVE UPPER SEAT TRACK RAIL COVER RH

    A01X5TU

    1. Using a screwdriver, detach the 2 claws and remove the cover.

      Tech Tips

      Tape the screwdriver tip before use.

  7. REMOVE NO. 1 SEAT CUSHION COVER

    A01WZX2

    1. Detach the 4 claws and remove the 2 covers.

  8. REMOVE REAR NO. 2 SEAT LEG SIDE COVER


    1. A01X0XI

      Remove the 4 screws and detach the 3 claws.

    2. A01X3A8

      Remove the bolt that is securing the fold seat stopper band and remove the seat leg side cover together with the fold seat stopper band.

  9. REMOVE FOLD SEAT STOPPER BAND ASSEMBLY


    1. Remove the fold seat stopper band from the seat leg side cover.

  10. REMOVE REAR SEAT SIDE HINGE FEMALE COVER

    B00111F

    1. Using a screwdriver, detach the 6 claws and remove the 2 covers.

      Tech Tips

      Tape the screwdriver tip before use.

  11. REMOVE REAR SEAT SIDE HINGE MALE COVER LH

    B00117D

    1. Detach the clip and remove the cover.

  12. REMOVE REAR SEAT SIDE HINGE MALE COVER RH


    1. Detach the clip and remove the cover.

  13. REMOVE REAR NO. 2 SEAT PROTECTOR


    1. A01X40C

      w/ Rear Seat Side Airbag:

      Detach the claw and remove the wire harness connector.

    2. w/ Seat Heater System:

      Detach the claw and remove the wire harness connector.

    3. A01X5PY

      Using a clip remover, remove the clip.

    4. Detach the claw and remove the seat protector from the seat hinge.

    5. Detach the 2 claws, open the protector and remove the wire harness.

  14. REMOVE REAR NO. 1 SEAT HINGE SUB-ASSEMBLY LH

    A01X2R6

    1. Remove the 2 nuts and hinge.

  15. REMOVE REAR NO. 1 SEAT HINGE SUB-ASSEMBLY RH

    A01X5I6

    1. w/ Rear Seat Side Airbag:

      Detach the wire harness clamp.

    2. w/ Seat Heater System:

      Detach the wire harness clamp.

    3. Remove the 2 nuts and hinge.

    4. B00112S

      Detach the cable clamp and disconnect the cable.

  16. REMOVE REAR SEAT COVER


    1. A01X3WE

      Detach the 12 claws.

    2. A01X4RS

      Remove the 3 screws.

    3. Detach the 2 claws and remove the cover.

  17. REMOVE REAR UNDER SIDE COVER LH

    A01X5VH

    1. Remove the 5 screws.

    2. Detach the clip and 2 claws, and remove the cover.

  18. REMOVE NO. 1 SEAT CUSHION PLATE

    B00117H

    1. Detach the 3 claws and remove the seat cushion plate.

  19. REMOVE REAR SEAT UNDER TRAY COVER RH

    B0010UA

    1. Remove the 2 screws.

    2. Detach the 4 claws and remove the cover.

  20. REMOVE REAR SEAT TRACK HANDLE SUB-ASSEMBLY


    1. B001142

      Remove the 2 screws and seat track handle.

    2. B0010WV

      Detach the 2 cable clamps and disconnect the 2 cables.

    3. B00110Y

      Detach the cable clamp and disconnect the cable.

  21. REMOVE FOLD SEAT LOCK CONTROL CABLE SUB-ASSEMBLY

  22. REMOVE SEAT CUSHION COVER WITH PAD


    1. w/ Rear Seat Side Airbag:


      1. Detach the side airbag wire harness clamps.

      2. Remove the side airbag wire harness through the hole in the seat cushion.

    2. w/ Seat Heater System:


      1. A01X1WM

        Disconnect the 2 seat heater connectors.

      2. A01XAKZ

        Remove the seatback heater wire harness through the hole in the seat cushion.

    3. Remove the seat cushion cover with pad.

  23. REMOVE REAR SEPARATE TYPE SEAT CUSHION COVER


    1. B001157E01
      *1 Fastening Tape

      Detach the 3 pieces of fastening tape.

    2. A01X1EN

      Remove the hog rings and cover.

  24. REMOVE REAR SEAT CUSHION HEATER ASSEMBLY (w/ Seat Heater System)

    B00119T

    1. Cut off the tack pins which fasten the seat heater to the seat cushion cover, and then remove the seat cushion heater from the seat cushion cover.

  25. REMOVE REAR SEATBACK COVER

    B001189E01
    *1 Protective Tape

    1. Using a screwdriver, detach the 4 claws and remove the cover.

      Tech Tips

      Tape the screwdriver tip before use.

  26. REMOVE REAR SEATBACK BOARD SUB-ASSEMBLY RH

    A01XBF1

    1. Detach the 2 claws on the top of the board.

    2. Pull up the board to detach the 2 claws on the bottom of the board and remove it.

  27. REMOVE REAR SEAT HEADREST ASSEMBLY

  28. REMOVE REAR NO. 1 SEAT HEADREST SUPPORT ASSEMBLY

    B00117N

    1. Detach the 4 claws and remove the 2 supports.

  29. REMOVE SEATBACK COVER WITH PAD


    1. A01X94U

      Remove the hog rings.

    2. A01X8BZ

      w/ Rear Seat Side Airbag:


      1. Remove the cap nut and seatback cover bracket from the seat frame.

      2. Remove the side airbag wire harness through the hole in the seatback.

    3. w/ Seat Heater System:


      1. B0010VRE01
        *1 Cable Tie

        Cut the cable tie and disconnect the seatback heater wire harness.

      2. A01X110

        Remove the seatback heater wire harness through the hole in the seatback.

    4. Remove the seatback cover with pad.

  30. REMOVE REAR SEPARATE TYPE SEATBACK COVER


    1. A01WZ6K

      w/ Rear Seat Side Airbag:

      Disconnect the seatback cover bracket from the seatback pad.

    2. A01X7OI

      Remove the hog rings and rear seatback cover.

  31. REMOVE REAR SEATBACK HEATER ASSEMBLY (w/ Seat Heater System)

    B0010TA

    1. Cut off the tack pins which fasten the seatback heater to the seatback cover, and then remove the seatback heater from the seatback cover.

  32. REMOVE REAR SEAT RECLINING COVER LH

    B0010XJ

    1. Remove the screw.

    2. Detach the claw and remove the cover.

  33. REMOVE REAR SEAT RECLINING COVER RH


    1. Remove the screw.

    2. Detach the claw and remove the cover.

  34. REMOVE REAR NO. 2 SEAT RECLINING COVER LH

    B00110C

    1. Remove the screw.

    2. Detach the clamp and remove the cover.

  35. REMOVE REAR NO. 1 SEAT RECLINING COVER RH

    A01X89L

    1. Remove the screw.

    2. Detach the claw and remove the cover.

  36. REMOVE RECLINING ADJUSTING CABLE ASSEMBLY RH

    A01WZ8H

    1. Detach the 2 cable clamps and disconnect the cable.

    2. Detach the clamp and remove the adjusting cable.

  37. REMOVE NO. 1 FOLD SEAT LOCK CONTROL CABLE ASSEMBLY

    A01X4FN

    1. Detach the 2 cable clamps and disconnect the cable.

    2. Detach the clamp and remove the lock control cable.

  38. REMOVE REAR SEATBACK FRAME SUB-ASSEMBLY RH

    A01WYVA

    1. Using a T40 "TORX" socket, remove the 4 bolts.

    2. Remove the seatback frame.

  39. REMOVE FOLD SEAT LOCK CONTROL CABLE SUB-ASSEMBLY

    A01X8J3

    1. Detach the 2 cable clamps and disconnect the 2 cables.

    2. Remove the 2 fold seat lock control cables.

  40. REMOVE REAR NO. 1 SEAT LOCK CABLE ASSEMBLY


    1. B001120

      Remove the 2 nuts and lower seat track bracket.

    2. A01X8AZ

      Remove the 2 nuts and lower seat track bracket.

    3. A01WZR9

      Detach the 3 cable clamps and disconnect the 3 cables.

    4. Detach the clamp and remove the seat lock cable.

  41. REMOVE REAR SEAT CUSHION HOLDER BRACKET RH (w/ Seat Heater System)

    A01X2T1

    1. Disconnect the seat wire connector.

    2. Remove the 2 screws and holder bracket.

  42. REMOVE SEAT HEATER CONTROL SUB-ASSEMBLY RH (w/ Seat Heater System)

    B00117U

    1. Detach the 2 claws and remove the seat heater control.

  43. REMOVE REAR NO. 1 SEAT INNER BELT ASSEMBLY RH

    Click here

  44. REMOVE REAR SEAT CUSHION FRAME SUB-ASSEMBLY RH

    A01WZ83

    1. Using a T40 "TORX" socket, remove the bolt.

    2. Remove the 5 nuts and seat cushion frame.

  45. REMOVE REAR NO. 1 SEAT LOCK CONTROL LEVER

    A01X2M4

    1. Remove the bolt and lock control lever.