REAR NO. 1 SEAT ASSEMBLY(for 60/40 Split Seat Type 40 Side) REMOVAL

CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE REAR NO. 2 SEAT CUSHION HINGE COVER

    B001Y77

    1. Using a screwdriver, detach the 6 claws and remove the cover.

      Tech Tips

      Tape the screwdriver tip before use.

  4. REMOVE REAR NO. 4 SEAT CUSHION HINGE COVER

    B001WR4

    1. Using a screwdriver, detach the 7 claws and remove the cover.

      Tech Tips

      Tape the screwdriver tip before use.

  5. REMOVE REAR NO. 1 SEAT CUSHION HINGE COVER


    1. B001X5H

      Operate the reclining adjuster release handle to move the seat into the position shown in the illustration.

    2. B001W9D

      Using a screwdriver, detach the 2 claws and 2 clips, and remove the cover.

      Tech Tips

      Tape the screwdriver tip before use.

  6. REMOVE REAR NO. 3 SEAT CUSHION HINGE COVER


    1. B001VYJ

      Using a screwdriver, detach the 2 claws and 2 clips, and remove the cover.

      Tech Tips

      Tape the screwdriver tip before use.

  7. REMOVE REAR NO. 1 SEAT ASSEMBLY RH


    1. B001WA1

      w/ Rear Seat Side Airbag:

      Disconnect the connector.

    2. w/ Seat Heater System:

      Disconnect the connector.

    3. B001XOQ

      Remove the 4 bolts and seat assembly.

      Note

      Be careful not to damage the vehicle body.

  8. REMOVE REAR NO. 1 SEAT ASSEMBLY LH


    1. Remove the rear No. 1 seat assembly LH Click here.

  9. REMOVE REAR NO. 1 SEAT PROTECTOR

    B001XB3E01

    1. Detach the 10 claws and remove the 2 seat protectors.

  10. REMOVE REAR NO. 2 SEAT PROTECTOR

    B001WY4E01

    1. Detach the 10 claws and remove the 2 seat protectors.

  11. REMOVE REAR STEP COVER

    Click here

  12. REMOVE REAR DOOR SCUFF PLATE LH

    Click here

  13. REMOVE REAR DOOR SCUFF PLATE RH

    Click here

  14. REMOVE REAR NO. 2 SEAT ASSEMBLY


    1. for Face to Face Seat Type:

      Remove the rear No. 2 seat assembly Click here.

    2. except Face to Face Seat Type:

      Remove the rear No. 2 seat assembly Click here.

  15. REMOVE REAR FLOOR MAT REAR SUPPORT PLATE

    Click here

  16. REMOVE REAR SEAT COVER CAP (w/ Rear No. 2 Seat, except Face to Face Seat Type)

    Click here

  17. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY LH


    1. w/ Sliding Roof:

      Remove the front quarter trim panel assembly LH Click here.

    2. w/o Sliding Roof:

      Remove the front quarter trim panel assembly LH Click here.

  18. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY RH


    1. w/ Sliding Roof:

      Remove the front quarter trim panel assembly RH Click here.

    2. w/o Sliding Roof:

      Remove the front quarter trim panel assembly RH Click here.

  19. REMOVE AIR DUCT PLUG (w/ Rear Air Conditioning System)

    Click here

  20. REMOVE REAR AIR DUCT GUIDE (w/ Rear Air Conditioning System)

    Click here

  21. REMOVE FRONT FLOOR CARPET ASSEMBLY

    Click here

  22. REMOVE REAR NO. 6 AIR DUCT (w/ Rear Air Conditioning System)

    Click here

  23. REMOVE REAR SEAT CUSHION LOCK STRIKER SUB-ASSEMBLY


    1. Remove the 10 bolts and 4 lock strikers.

      B001W30E01
      *1 RH Side:
      *2 LH Side: