SEAT BELT CONTROL ECU(for RHD) INSTALLATION

PROCEDURE


  1. INSTALL SEAT BELT CONTROL ECU

    A01X5KM

    1. Install the ECU with the nut.

      Torque:
      7.0 N*m  { 71 kgf*cm, 62 in.*lbf }

    2. Connect the 2 connectors.

  2. INSTALL LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL

    Click here

  3. INSTALL NO. 3 INSTRUMENT CLUSTER FINISH PANEL GARNISH

    Click here

  4. INSTALL LOWER INSTRUMENT PANEL (w/o Passenger Side Knee Airbag)

    Click here

  5. INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY (w/ Passenger Side Knee Airbag)

    Click here

  6. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Floor Under Cover)

    Click here

  7. INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH

    Click here

  8. INSTALL NO. 1 INSTRUMENT PANEL FINISH CUSHION

    Click here

  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Passenger Side Knee Airbag)

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  10. CHECK SRS WARNING LIGHT (w/ Passenger Side Knee Airbag)


    1. Check the SRS warning light Click here.