REAR AIRBAG SENSOR INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedures for the LH side and RH side.

  • The procedures listed below are for the LH side.

PROCEDURE


  1. INSTALL REAR AIRBAG SENSOR


    1. B001WK6

      Check that the ignition switch is turned off.

    2. Check that the cable is disconnected from the battery negative (-) terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Install the rear airbag sensor with the bolt.

      Torque:
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

      Note


      • If the rear airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.

      • When installing the rear airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

    4. Check that there is no looseness in the installation parts of the rear airbag sensor.

    5. Connect the connector.

  2. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY LH (w/ Sliding Roof)

    Click here

  3. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY LH (w/o Sliding Roof)

    Click here

  4. INSTALL REAR SEAT COVER CAP (w/ Sliding Roof)

    Click here

  5. INSTALL REAR SEAT COVER CAP (w/o Sliding Roof)

    Click here

  6. INSTALL REAR DOOR SCUFF PLATE LH (w/ Sliding Roof)

    Click here

  7. INSTALL REAR DOOR SCUFF PLATE LH (w/o Sliding Roof)

    Click here

  8. INSTALL REAR STEP COVER (w/ Sliding Roof)

    Click here

  9. INSTALL REAR STEP COVER (w/o Sliding Roof)

    Click here

  10. INSTALL REAR FLOOR MAT REAR SUPPORT PLATE (w/ Sliding Roof)

    Click here

  11. INSTALL REAR FLOOR MAT REAR SUPPORT PLATE (w/o Sliding Roof)

    Click here

  12. INSTALL REAR NO. 2 SEAT ASSEMBLY LH (for Split Bench Seat Type)


    1. Install the rear No. 2 seat assembly LH Click here.

  13. INSTALL REAR NO. 2 SEAT ASSEMBLY LH


    1. Install the rear No. 2 seat assembly LH Click here.

  14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  15. CHECK SRS WARNING LIGHT


    1. Check the SRS warning light Click here.