REAR AIRBAG SENSOR REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedures for the LH side and RH side.

  • The procedures listed below are for the LH side.

PROCEDURE


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE REAR NO. 2 SEAT ASSEMBLY LH


    1. Remove the rear No. 2 seat assembly LH Click here.

  3. REMOVE REAR NO. 2 SEAT ASSEMBLY LH (for Split Bench Seat Type)


    1. Remove the rear No. 2 seat assembly LH Click here.

  4. REMOVE REAR FLOOR MAT REAR SUPPORT PLATE (w/ Sliding Roof)

    Click here

  5. REMOVE REAR FLOOR MAT REAR SUPPORT PLATE (w/o Sliding Roof)

    Click here

  6. REMOVE REAR STEP COVER (w/ Sliding Roof)

    Click here

  7. REMOVE REAR STEP COVER (w/o Sliding Roof)

    Click here

  8. REMOVE REAR DOOR SCUFF PLATE LH (w/ Sliding Roof)

    Click here

  9. REMOVE REAR DOOR SCUFF PLATE LH (w/o Sliding Roof)

    Click here

  10. REMOVE REAR SEAT COVER CAP (w/ Sliding Roof)

    Click here

  11. REMOVE REAR SEAT COVER CAP (w/o Sliding Roof)

    Click here

  12. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY LH (w/ Sliding Roof)

    Click here

  13. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY LH (w/o Sliding Roof)

    Click here

  14. REMOVE REAR AIRBAG SENSOR


    1. B001WK6

      Remove the bolt and rear airbag sensor.

    2. Disconnect the connector.