SIDE AIRBAG SENSOR INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedures for the RH and LH.

  • The procedures listed below are the LH side.

PROCEDURE


  1. INSTALL SIDE AIRBAG SENSOR


    1. B001WYU

      Check that the ignition switch is off.

    2. Check that the cable is disconnected from the battery negative (-) terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Install the side airbag sensor with the bolt.

      Torque:
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

      Note


      • If the side airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.

      • When installing the side airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

    4. Check that there is no looseness in the installation parts of the side airbag sensor.

    5. Connect the connector.

  2. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  3. INSTALL ASSIST GRIP COVER LH

    Click here

  4. INSTALL MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY

    Click here

  5. INSTALL FRONT DOOR INSIDE HANDLE BEZEL LH

    Click here

  6. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH

    Click here

  7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  8. CHECK SRS WARNING LIGHT


    1. Check the SRS warning light Click here.