FRONT PASSENGER AIRBAG ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing Click here.

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (- ) battery terminal notices before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note


    • After the ignition switch is turned off, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch off, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE INSTRUMENT PANEL SAFETY PAD


    1. Remove the instrument panel safety pad Click here.

  4. REMOVE FRONT PASSENGER AIRBAG ASSEMBLY


    1. B001ZBT

      Detach the claw and remove the wire.

    2. Disconnect the 2 connectors and remove the instrument panel wire from the front passenger airbag.

      Note

      When handling the airbag connector, take care not to damage the airbag wire harness.

    3. B001Z4CE01
      *1 for LHD:
      *2 for RHD:

      Remove the 2 screws.

    4. B001YLBE02
      *1 for LHD:
      *2 Hook (B)
      *3 Hook (A)
      *4 for RHD:

      Detach the 5 hooks (A).

    5. Detach the 5 hooks (B) and remove the front passenger airbag from the instrument panel.