KNEE AIRBAG ASSEMBLY(for Front Passenger Side) REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE

1. PRECAUTION

   CAUTION:

   Be sure to read Precaution thoroughly before servicing Click here.

   Note

   After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work Click here.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

3. REMOVE FRONT DOOR SCUFF PLATE LH (for Double Swing Out Type Back Door)

   Click here

4. REMOVE FRONT DOOR SCUFF PLATE RH (except Double Swing Out Type Back Door)

   Click here

5. REMOVE NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION (for Double Swing Out Type Back Door)

   Click here

6. REMOVE NO. 1 INSTRUMENT PANEL FINISH CUSHION (except Double Swing Out Type Back Door)

   Click here

7. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH (for Double Swing Out Type Back Door)

   Click here

8. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH (except Double Swing Out Type Back Door)

   Click here

9. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

   Click here

10. REMOVE FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY

    
    
    1. 

       Text in Illustration

       *a	Connector Lock
       	Protective Tape

       Remove the 4 bolts.

    2. Detach the 4 claws and remove the front passenger side knee airbag assembly.

    3. Using a screwdriver, release the connector lock and disconnect the airbag connector.

       Note

       When handling the airbag connector, take care not to damage the airbag wire harness.

       CAUTION:

       Tape the screwdriver tip before use.