SPIRAL CABLE REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing Click here.

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (- ) battery terminal notices before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

  4. REMOVE STEERING WHEEL ASSEMBLY

    Click here

  5. REMOVE LOWER STEERING COLUMN COVER

    for Manual Tilt and Manual Telescopic Steering Column:

    Click here

    for Power Tilt and Power Telescopic Steering Column:

    Click here

  6. REMOVE UPPER STEERING COLUMN COVER

    for Manual Tilt and Manual Telescopic Steering Column:

    Click here

    for Power Tilt and Power Telescopic Steering Column:

    Click here

  7. REMOVE SPIRAL CABLE SUB-ASSEMBLY


    1. Disconnect each connector.

      Note

      When handling the airbag connector, take care not to damage the airbag wire harness.

    2. B001W2U

      Detach the 3 claws and remove the spiral cable sub-assembly.

  8. REMOVE SPIRAL CABLE (w/ Steering Angle Sensor)

    Note


    • Remove the spiral cable from the steering sensor only when replacing it.

    • Removing the steering sensor from the spiral cable sub-assembly without using a lock pin may result in a misaligned center position of the steering sensor. Therefore, make sure to use the lock pin provided with a new spiral cable when removing the steering sensor from the spiral cable sub-assembly.


    1. Install the lock pin to the steering sensor.

      Note


      • Use the lock pin provided with a new spiral cable.

      • Do not remove the lock pin before the spiral cable is installed to the steering sensor.

      B001YY4
    2. B001YEA

      Detach the 6 claws and remove the spiral cable from the steering sensor.