KNEE AIRBAG ASSEMBLY(for Driver Side) INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY

   
   

   1. Connect the connector.

      

      *1	for LHD:
      *2	for RHD:

      Note

      When handling the airbag connector, take care not to damage the airbag wire harness.

   2. Install the driver side knee airbag with the 5 bolts.

      Torque:

      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

2. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

   Click here

3. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Floor Under Cover)

   Click here

4. INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH

   Click here

5. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH

   Click here

6. INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH

   Click here

7. INSTALL NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION

   Click here

8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

9. CHECK SRS WARNING LIGHT

   
   

   1. Check the SRS warning light Click here.