KNEE AIRBAG ASSEMBLY(for Driver Side) REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE

1. Click here

   DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

   Note:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

2. Click here

   REMOVE NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION

   Click here

3. Click here

   REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH

   Click here

4. Click here

   REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH

   Click here

5. Click here

   REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH

   Click here

6. Click here

   REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Floor Under Cover)

   Click here

7. Click here

   REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

   Click here

8. Click here

   REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY

   
   
   1. 

      Table 1.

      *1	for LHD:
      *2	for RHD:

      Remove the 5 bolts and driver side knee airbag.

   2. Disconnect the connector.

      Note:

      When handling the airbag connector, take care not to damage the airbag wire harness.