KNEE AIRBAG ASSEMBLY(for Driver Side) INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY

   
   

   1. Check that the ignition switch is off.

   2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

   3. 

      Text in Illustration

      *a	Connector Lock

      Connect the airbag connector and lock the connector lock.

      Note

      When handling the airbag connector, take care not to damage the airbag wire harness.

   4. Install the driver side knee airbag assembly with the 5 bolts.

      Torque:

      12 N*m  { 122 kgf*cm, 9 ft.*lbf }

2. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

   Click here

3. INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH

   Click here

4. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH

   Click here

5. INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH (for Double Swing Out Type Back Door)

   Click here

6. INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH (except Double Swing Out Type Back Door)

   Click here

7. INSTALL NO. 1 INSTRUMENT PANEL FINISH CUSHION (for Double Swing Out Type Back Door)

   Click here

8. INSTALL NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION (except Double Swing Out Type Back Door)

   Click here

9. INSTALL COWL SIDE TRIM BOARD RH (for Double Swing Out Type Back Door)

   Click here

10. INSTALL COWL SIDE TRIM BOARD LH (except Double Swing Out Type Back Door)

    Click here

11. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

12. INSTALL FRONT DOOR SCUFF PLATE RH (for Double Swing Out Type Back Door)

    Click here

13. INSTALL FRONT DOOR SCUFF PLATE LH (except Double Swing Out Type Back Door)

    Click here

14. INSTALL INSTRUMENT SIDE PANEL RH (for Double Swing Out Type Back Door)

    Click here

15. INSTALL INSTRUMENT SIDE PANEL LH (except Double Swing Out Type Back Door)

    Click here

16. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

17. CHECK SRS WARNING LIGHT

    
    

    1. Check the SRS warning light Click here.