COMBINATION METER(w/ Multi-information Display) REMOVAL

PROCEDURE


  1. DISABLE AUTO TILT AWAY FUNCTION


    1. Disable the function by changing the customize parameter Click here.

      Note

      Record the current customize parameter setting (whether the Autoaway/Return function is enabled or disabled) in order to restore the current setting after finishing the operation.

      Tech Tips

      Performing the above operation causes the Autoaway/Return function to be disabled when the engine switch is turned off.

    2. Turn the engine switch on (IG). Operate the tilt and telescopic switch to fully extend and lower the steering column assembly.

    3. Turn the engine switch off.

  2. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH


    1. A01X2ZME01
      *1 Protective Tape

      Place protective tape as shown in the illustration.

    2. Using a moulding remover, detach the 3 claws and remove the panel garnish.

  5. REMOVE NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION


    1. A01X46HE01
      *1 Protective Tape

      Place protective tape as shown in the illustration.

    2. Using a moulding remover, detach the 7 claws and remove the panel cushion.

  6. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH


    1. A01X3HJ

      Remove the clip.

    2. Remove the screw.

    3. Detach the 8 claws.

    4. Remove the panel pad and disconnect the connectors and 2 clamps.

  7. REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH


    1. A01WZF9E01
      *1 Protective Tape

      Place protective tape as shown in the illustration.

    2. Using a moulding remover, detach the 2 claws and remove the panel garnish.

  8. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY


    1. A01WZZ1

      Detach the 4 claws.

    2. A01X74N

      Detach the 9 claws.

    3. A01X448

      Remove the finish panel and disconnect the connector.

  9. REMOVE COMBINATION METER ASSEMBLY


    1. A01X75O

      Remove the 4 screws.

    2. A01X1OO

      Disconnect the connectors, and remove the combination meter by pulling it up in the direction of the arrow in the illustration.