COMBINATION METER REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. DISABLE AUTOAWAY/RETURN FUNCTION (for Power Tilt and Power Telescopic Steering Column)


    1. Disable the autoaway/return function by changing the customize parameter Click here.

      CAUTION:

      Record the current customize parameter setting (whether the autoaway/return function is enabled or disabled) in order to restore the current setting after finishing the operation.

      Tech Tips

      Performing the above operation causes the autoaway/return function to be disabled when the engine switch is turned off.

    2. Turn the engine switch on (IG). Operate the tilt and telescopic switch to fully extend and lower the steering column assembly.

    3. Turn the ignition switch off.

  2. REMOVE NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION

    Click here

  3. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH

    Click here

  4. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH

    Click here

  5. REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH

    Click here

  6. REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

    A01X45ME01

    1. Put protective tape around the No. 2 instrument cluster finish panel sub-assembly.

      Text in Illustration
      *a Protective Tape
    2. A01X61H

      Detach the 4 claws.

    3. A01X92Z

      Detach the 9 claws.

    4. Disconnect the connectors and remove the No. 2 instrument cluster finish panel sub-assembly.

  7. REMOVE COMBINATION METER ASSEMBLY

    A01X464

    1. Remove the 4 screws.

    2. Disconnect the connectors and remove the combination meter assembly.