ROOM LIGHT(for Rear) INSPECTION

PROCEDURE

1. INSPECT NO. 3 ROOM LIGHT ASSEMBLY (for LED Type)

   
   

   1. Inspect the room light.

      
      
      1. 

         Text in Illustration

         *a	Component without harness connected (No. 3 Room Light Assembly)

         Apply battery voltage to the connector and check the light illumination condition.

         OK
         Measurement Condition Condition Specified Condition Battery positive (+) → 2 (DL) Battery negative (-) → 4 (DB) Room light switch on Room light illuminates

         If the result is not as specified, replace the No. 3 room light assembly.

   2. Inspect the room light (for Door-linked).

      
      
      1. 

         Text in Illustration

         *a	Component without harness connected (No. 3 Room Light Assembly)

         Apply battery voltage to the connector and check the light illumination condition.

         OK
         Measurement Condition Condition Specified Condition Battery positive (+) → 4 (DB)) Battery negative (-) → 3 (L) Room light switch on Room light illuminates

         If the result is not as specified, replace the No. 3 room light assembly.