ROOM LIGHT(for Front) ON-VEHICLE INSPECTION

PROCEDURE


  1. INSPECT MAP LIGHT ASSEMBLY


    1. Remove the map light assembly with the connector connected.

    2. A01XAPFE04
      Text in Illustration
      *a

      Component with harness connected

      (Map Light Assembly)

      Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      6 (RILL) - 17 (GND9) Battery save system (interior light auto cut function) operating → Battery save system (interior light auto cut function) not operating 11 to 14 V
      32 (ILLB) - 17 (GND9) 11 to 14 V
      13 (GILL) - 17 (GND9) Light control switch tail 11 to 14 V
      6 (RILL) - 17 (GND9) No. 1 room light on → off 11 to 14 V

      If the result is not as specified, replace the map light assembly.

    3. A01X9UOE03
      Text in Illustration
      *a

      Component with harness connected

      (Map Light Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      17 (GND9) - Body ground Always Below 1 Ω
      3 (GND5) - Body ground Always Below 1 Ω

      If the result is not as specified, replace the map light assembly.