ENTRY LOCK AND UNLOCK SWITCH(for Rear) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedures for the LH side and RH side.

  • The procedures listed below are for the LH side.

PROCEDURE


  1. INSTALL REAR DOOR OUTSIDE HANDLE ASSEMBLY LH


    1. A01X4FB

      Insert the front end of the rear door outside handle assembly into the rear door outside handle frame.

      Note

      If the bellcrank lever is not pulled and held when installing the outside handle, the bellcrank lever will interfere with the outside handle and the release plate may be damaged.

    2. Insert the rear end of the rear door outside handle assembly into the rear door outside handle frame. Next, slide the rear door outside handle assembly toward the front of the vehicle to install it.

    3. A01WZF7

      Using a T30 ''TORX'' socket, tighten the screw.

    4. Connect the connector.

  2. INSTALL REAR DOOR OUTSIDE HANDLE COVER LH

    Click here

  3. INSTALL REAR DOOR LOCK ASSEMBLY LH

    Click here

  4. INSTALL REAR DOOR SERVICE HOLE COVER LH

    Click here

  5. INSTALL COURTESY LIGHT ASSEMBLY (w/ Courtesy Light)

    Click here

  6. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  7. INSTALL ASSIST GRIP COVER LH

    Click here

  8. INSTALL REAR DOOR INSIDE HANDLE BEZEL LH

    Click here

  9. INSTALL REAR DOOR ARMREST BASE PANEL ASSEMBLY LH

    Click here

  10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.