ENTRY LOCK AND UNLOCK SWITCH(for Rear) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedures for the LH side and RH side.

  • The procedures listed below are for the LH side.

PROCEDURE


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE REAR DOOR ARMREST BASE PANEL ASSEMBLY LH

    Click here

  3. REMOVE REAR DOOR INSIDE HANDLE BEZEL LH

    Click here

  4. REMOVE ASSIST GRIP COVER LH

    Click here

  5. REMOVE COURTESY LIGHT ASSEMBLY (w/ Courtesy Light)

    Click here

  6. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  7. REMOVE REAR DOOR SERVICE HOLE COVER LH

    Click here

  8. REMOVE REAR DOOR LOCK ASSEMBLY LH

    Click here

  9. REMOVE REAR DOOR OUTSIDE HANDLE COVER LH

    Click here

  10. REMOVE REAR DOOR OUTSIDE HANDLE ASSEMBLY LH


    1. A01WZF7

      Using a T30 "TORX" wrench, loosen the screw.

    2. Disconnect the connector.

    3. A01X3IP

      Remove the handle by sliding and pulling it in the direction indicated by the arrow in the illustration.