ENTRY LOCK AND UNLOCK SWITCH(for Front) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedures for the LH side and RH side.

  • The procedures listed below are for the LH side.

PROCEDURE


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE FRONT LOWER DOOR FRAME BRACKET GARNISH LH

    Click here

  3. REMOVE FRONT DOOR ARMREST BASE PANEL ASSEMBLY LH

    Click here

  4. REMOVE FRONT DOOR INSIDE HANDLE BEZEL LH

    Click here

  5. REMOVE DOOR ASSIST GRIP COVER LH

    Click here

  6. REMOVE COURTESY LIGHT ASSEMBLY (w/ Courtesy Light)

    Click here

  7. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  8. REMOVE FRONT DOOR SERVICE HOLE COVER LH

    Click here

  9. REMOVE FRONT DOOR OUTSIDE HANDLE COVER LH

    Click here

  10. REMOVE FRONT DOOR HANDLE ASSEMBLY OUTSIDE LH


    1. A01X6QR

      Disconnect the connector.

    2. Using a T30 "TORX" wrench, loosen the screw.

    3. A01XACT

      Remove the handle by sliding and pulling it in the direction indicated by the arrow in the illustration.

      Note

      If the release plate is not pulled and held when removing the handle, the release plate will interfere with the handle and become damaged.