ENTRY LOCK AND UNLOCK SWITCH(for Front) REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

2. REMOVE FRONT LOWER DOOR FRAME BRACKET GARNISH LH

   Click here

3. REMOVE FRONT UPPER ARMREST BASE PANEL LH

   Click here

4. REMOVE FRONT DOOR INSIDE HANDLE BEZEL LH

   Click here

5. REMOVE DOOR ASSIST GRIP COVER LH

   Click here

6. REMOVE COURTESY LIGHT ASSEMBLY (w/ Courtesy Light)

   Click here

7. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

   Click here

8. REMOVE FRONT DOOR SERVICE HOLE COVER LH

   Click here

9. REMOVE FRONT DOOR OUTSIDE HANDLE COVER

   Click here

10. REMOVE FRONT DOOR OUTSIDE HANDLE ASSEMBLY LH

    
    

    1. 

       Using a screwdriver, detach the 2 claws of the connector cover in the direction indicated and disconnect the connector cover.

       Text in Illustration

       Protective Tape

       Tech Tips

       Tape the screwdriver tip before use.

    2. 

       Using a screwdriver, detach the 2 claws of the connector in the direction indicated and disconnect the connector.

       Text in Illustration

       Protective Tape

       Tech Tips

       Tape the screwdriver tip before use.

    3. 

       Detach the 2 claws and remove the holder in the direction indicated by the arrow in the illustration.

    4. 

       Remove the front door outside handle assembly LH by sliding and pulling it in the direction indicated by the arrow in the illustration.

       Note

       If the release plate is not pulled and held when removing the front door outside handle assembly LH, the release plate will interfere with the front door outside handle assembly LH and become damaged.