BACK DOOR LOCK(for Double Swing Out Type) INSTALLATION

PROCEDURE


  1. INSTALL BACK DOOR LOCK ASSEMBLY


    1. Apply MP grease to the sliding parts of the back door lock assembly.

    2. A01X2TX

      Using a T30 "TORX" socket wrench, install the back door lock assembly with the 4 screws.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

    3. Connect the 2 connectors.

    4. A01X7G1E02

      Connect the back door lock cable assembly to the back door remote control assembly.

    5. Connect the back door lock locking link to the back door lock control assembly and rotate the snap as shown in the illustration.

      Text in Illustration
      *1 Snap
      *2 Back Door Lock Locking Link
      *3 Back Door Lock Control Assembly
      *4 Back Door Remote Control Assembly
      *5 Back Door Lock Cable Assembly

  2. INSTALL BACK DOOR SERVICE HOLE COVER LH

    Click here

  3. INSTALL BACK DOOR INSIDE HANDLE ASSEMBLY LH

    Click here

  4. INSTALL REAR ASSIST GRIP REINFORCEMENT LH

    Click here

  5. INSTALL BACK DOOR TRIM PANEL ASSEMBLY LH

    Click here

  6. INSTALL DOOR INSIDE HANDLE BEZEL LH

    Click here

  7. INSTALL ASSIST GRIP LH

    Click here