REAR DOOR LOCK INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedures for the LH side and RH side.

  • The procedures listed below are for the LH side.

PROCEDURE


  1. INSTALL REAR DOOR INSIDE LOCKING CABLE ASSEMBLY LH

    Click here

  2. INSTALL REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH

    Click here

  3. INSTALL REAR DOOR LOCK ASSEMBLY LH


    1. B001XDL

      Apply MP grease to the sliding parts of the rear door lock assembly.

    2. Insert the rear door lock assembly to the rear door outside handle release plate, and set it to the rear door panel.

    3. Make sure that the rear door outside handle frame release plate is securely connected to the rear door lock assembly.

    4. Using a T30 ''TORX'' wrench, the 3 screws.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

  4. INSTALL REAR DOOR SERVICE HOLE COVER LH

    Click here

  5. INSTALL COURTESY LIGHT ASSEMBLY (w/ Courtesy Light)

    Click here

  6. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  7. INSTALL ASSIST GRIP COVER LH

    Click here

  8. INSTALL REAR DOOR INSIDE HANDLE BEZEL LH

    Click here

  9. INSTALL REAR DOOR ARMREST BASE PANEL ASSEMBLY LH

    Click here

  10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.