REAR DOOR LOCK REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedures for the LH side and RH side.

  • The procedures listed below are for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE REAR DOOR ARMREST BASE PANEL ASSEMBLY LH

    Click here

  4. REMOVE REAR DOOR INSIDE HANDLE BEZEL LH

    Click here

  5. REMOVE ASSIST GRIP COVER LH

    Click here

  6. REMOVE COURTESY LIGHT ASSEMBLY (w/ Courtesy Light)

    Click here

  7. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  8. REMOVE REAR DOOR SERVICE HOLE COVER LH

    Click here

  9. REMOVE REAR DOOR LOCK ASSEMBLY LH


    1. B001WKW

      Using a T30 ''TORX'' socket, remove the 3 screws and door lock.

      Note

      Be careful when removing the screws as the door lock may fall and become damaged.

  10. REMOVE REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH

    Click here

  11. REMOVE REAR DOOR INSIDE LOCKING CABLE ASSEMBLY LH

    Click here