FRONT DOOR LOCK INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedures for the LH side and RH side.

  • The procedures listed below are for the LH side.

PROCEDURE


  1. INSTALL FRONT DOOR INSIDE LOCKING LH CABLE ASSEMBLY

    Click here

  2. INSTALL FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH

    Click here

  3. INSTALL FRONT DOOR LOCK ASSEMBLY LH

    B001ZKY

    1. Apply MP grease to the sliding parts of the front door lock assembly.

    2. Insert the front door lock open rod to the front door lock assembly.

    3. Make sure that the front door lock open rod is securely connected to the front door lock assembly.

    4. Using a T30 "TORX" wrench, install the door lock with the 3 screws.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

  4. INSTALL FRONT DOOR OUTSIDE HANDLE COVER LH

    Click here

  5. INSTALL FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY LH

    Click here

  6. INSTALL FRONT NO. 2 DOOR STIFFENER CUSHION

    Click here

  7. INSTALL FRONT DOOR SERVICE HOLE COVER LH

    Click here

  8. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  9. INSTALL COURTESY LIGHT ASSEMBLY (w/ Courtesy Light)

    Click here

  10. INSTALL DOOR ASSIST GRIP COVER LH

    Click here

  11. INSTALL FRONT DOOR INSIDE HANDLE BEZEL LH

    Click here

  12. INSTALL FRONT DOOR ARMREST BASE PANEL ASSEMBLY LH

    Click here

  13. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH

    Click here

  14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  15. CHECK SRS WARNING LIGHT


    1. Check the SRS warning light Click here.