WINCH UNIT INSTALLATION

PROCEDURE


  1. INSTALL WINCH ASSEMBLY


    1. A01WZTS

      Using a crane or equivalent, install the winch assembly.

      CAUTION:

      Be careful as the winch assembly is very heavy.

    2. A01WZ61

      Connect the wire with the nut.

      Torque:
      9.3 N*m  { 95 kgf*cm, 83 in.*lbf }

    3. Connect the connector.

    4. A01X9TQ

      Move the cover in the direction indicated by the arrow shown in the illustration and attach the 2 claws.

    5. A01X018E01

      Install the mounting bracket with the 9 bolts.

      Torque:
      for bolt A
      33 N*m  { 336 kgf*cm, 24 ft.*lbf }
      for bolt B
      19 N*m  { 194 kgf*cm, 15 ft.*lbf }

  2. INSTALL WINCH CONTROL WIRE


    1. A01XA2H

      Install the winch control wire with the 2 nuts.

      Torque:
      5 N*m  { 51 kgf*cm, 45 in.*lbf }

  3. INSTALL TRANSMISSION OIL COOLER AIR DUCT (w/ Oil Cooler)

    Click here

  4. INSTALL RADIATOR SIDE DEFLECTOR LH

    Click here

  5. INSTALL RADIATOR SIDE DEFLECTOR RH (w/o Oil Cooler)

    Click here

  6. INSTALL FRONT UPPER CENTER BUMPER RETAINER

    Click here

  7. INSTALL HEADLIGHT ASSEMBLY LH

    Click here

  8. INSTALL HEADLIGHT ASSEMBLY RH

    Click here

  9. INSTALL FRONT BUMPER EXTENSION LH

    Click here

  10. INSTALL FRONT BUMPER EXTENSION RH

    Click here

  11. INSTALL FRONT BUMPER COVER

    Click here

  12. INSTALL RADIATOR GRILLE ASSEMBLY

    Click here

  13. INSTALL FRONT BUMPER WINCH COVER SUB-ASSEMBLY

    Click here

  14. INSTALL UPPER RADIATOR SUPPORT SEAL

    Click here

  15. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

    Click here

  16. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

    Click here

  17. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.