WINCH SYSTEM ON-VEHICLE INSPECTION

PROCEDURE


  1. INSPECT REMOTE CONTROL SWITCH ASSEMBLY


    1. A01X3KG

      Connect the remote control switch connector.

    2. A01X3XQ

      Turn the engine switch on (IG) and check that the power indicator light illuminates.

    3. Press the winch control switch, and check that the winch operates.

      Note

      Be careful not to tighten or strain the winch wire.

    4. Turn the engine switch off.

  2. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

    Click here

  3. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

    Click here

  4. REMOVE UPPER RADIATOR SUPPORT SEAL


    1. for Gasoline Engine:

      Remove the upper radiator support seal Click here.

    2. for Diesel Engine:

      Remove the upper radiator support seal Click here.

  5. REMOVE FRONT BUMPER WINCH COVER SUB-ASSEMBLY

  6. REMOVE RADIATOR GRILLE ASSEMBLY

    Click here

  7. REMOVE FRONT BUMPER COVER

    Click here

  8. INSPECT OVERHEAT TEMPERATURE INDICATOR


    1. A01X991

      Remove the 4 screws and cover.

    2. A01WZJV

      Disconnect the motor relay connector.

    3. A01XA2H

      Remove the 2 nuts.

    4. Pull the bumper side winch control wire out of the bumper.

    5. Connect the bumper side winch control wire connector to the vehicle side winch control wire connector.

    6. Connect the bumper side winch control wire connector to the winch control switch connector.

    7. A01XAPA

      Turn the engine switch on (IG) and check that the overheat temperature indicator light illuminates and the buzzer sounds.

    8. Turn the engine switch off.

    9. Disconnect the bumper side winch control wire connector from the winch control switch connector.

    10. Disconnect the bumper side winch control wire connector from the vehicle side winch control wire connector.

    11. Pass the bumper side winch control wire through the bumper.

    12. A01XA2H

      Install the 2 nuts.

    13. A01WZJV

      Connect the motor relay connector.

    14. A01X991

      Install the cover with the 4 screws.

  9. INSTALL FRONT BUMPER COVER

    Click here

  10. INSTALL RADIATOR GRILLE ASSEMBLY

    Click here

  11. INSTALL FRONT BUMPER WINCH COVER SUB-ASSEMBLY

  12. INSTALL UPPER RADIATOR SUPPORT SEAL


    1. for Gasoline Engine:

      Install the upper radiator support seal Click here.

    2. for Diesel Engine:

      Install the upper radiator support seal Click here.

  13. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

    Click here

  14. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

    Click here