G-BOOK SYSTEM HOW TO PROCEED WITH TROUBLESHOOTING

DTC Code DTC Name
HOW TO PROCEED WITH TROUBLESHOOTING

CAUTION / NOTICE / HINT

Tech Tips


  • Use the following procedure to troubleshoot the G-BOOK system.

  • *: Use the GTS.

PROCEDURE


  1. VEHICLE BROUGHT TO WORKSHOP

    Result
    Proceed to
    NEXT

    NEXT

  2. CHECK PROBLEM SYMPTOM


    1. The G-BOOK system provides a variety of functions. Therefore, it is important to identify whether a malfunction is related to the communication system, including radio wave conditions, or any other systems. Carefully confirm the conditions that caused the malfunction in order to determine if a temporary problem with the radio wave signal condition caused the malfunction.

      Displayed Message and Problem Symptom Cause
      A message is displayed temporarily indicating to try again after moving the vehicle because the center cannot be accessed, as the screen cannot be displayed due to a busy line, etc. This is caused when there is a problem with the radio wave signal conditions or when the base station is busy. This is not a malfunction (inform the customer that this is not a malfunction and ask them to use the system as is).
      A message is displayed temporarily indicating to try again after waiting for a while because the information cannot be retrieved due to a busy line, etc. This is caused when there is a problem with the radio wave signal conditions or when the base station is busy. This is not a malfunction (inform the customer that this is not a malfunction and ask them to use the system as is).
      A message is displayed temporarily indicating to try again after waiting for a while because the lines are busy. This is caused when there is a problem with the radio wave signal conditions or when the base station is busy. This is not a malfunction (inform the customer that this is not a malfunctions and ask them to use the system as is).
      Result
      Proceed to
      NEXT

    NEXT

  3. INSPECT BATTERY VOLTAGE


    1. Measure the battery voltage.

      Standard voltage
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

      Result
      Proceed to
      NEXT

    NEXT

  4. CHECK CAN COMMUNICATION SYSTEM*


    1. Use the GTS to check if the CAN communication system is functioning normally.

      Click here

      Result
      Result Proceed to
      CAN communication system DTC is not output. A
      CAN communication system DTC is output. B

    B

    GO TO CAN COMMUNICATION SYSTEM Click here

    A

  5. PROBLEM SYMPTOMS TABLE


    1. Refer to Problem Symptoms Table.

      Click here

      Result
      Result Proceed to
      Fault is not listed in Problem Symptoms Table. A
      Fault is listed in Problem Symptoms Table. CAN communication system DTC is output. B

      Tech Tips

      If the symptom does not recur and no DTCs are output, attempt to reproduce the symptoms.

      Click here


    B

    GO TO STEP 7 Click here

    A

  6. PERFORM TROUBLESHOOTING BASED ON MALFUNCTION SYMPTOM


    1. Refer to Terminals of ECU.

      Click here

      Result
      Proceed to
      NEXT

    NEXT

  7. CHECK CIRCUIT


    1. Adjust, repair or replace as necessary.

      Note

      If the multi-media module receiver assembly is replaced, perform the vehicle contract setting.

      Click here

      Result
      Proceed to
      NEXT

    NEXT

  8. PERFORM CONFIRMATION TEST

    Result
    Proceed to
    NEXT

    NEXT

    END