NAVIGATION SYSTEM, Diagnostic DTC:B1574

DTC Code DTC Name
B1574 GVIF Disconnected (from Park Assist/Monitoring ECU to EMV/MM Integrated Device)

DESCRIPTION

DTC Code DTC Detection Condition Trouble Area
B1574 GVIF disconnected (from Parking assist ECU to Multi-display)

  • Harness or connector (GVIF cable)

  • Multi-display assembly

WIRING DIAGRAM

B001VKGE05

PROCEDURE


  1. CLEAR DTC


    1. Clear the DTCs Click here.


    NEXT

  2. CHECK DTC


    1. Recheck for DTCs and check if the same DTC is output again Click here.

      OK
      No DTCs are output.

    OK

    USE SIMULATION METHOD TO CHECK Click here

    NG

  3. CHECK HARNESS AND CONNECTOR (GVIF CABLE)


    1. Check that the digital signal lines between the multi-display assembly and parking assist ECU are not sharply bent or pinched, and that the connectors are properly connected and there are no other installation problems.

      OK
      There are no installation problems.

    NG

    REPLACE HARNESS AND CONNECTOR (GVIF CABLE)

    OK

  4. REPLACE HARNESS AND CONNECTOR (GVIF CABLE)


    1. B001Z5EE02
      Text in Illustration
      *a

      Front view of wire harness connector

      (to Parking Assist ECU)
      *b

      Front view of wire harness connector

      (to Multi-display Assembly)

      Disconnect the F100 multi-display assembly connector.

    2. Disconnect the F104 parking assist ECU connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      F100-1 (GVI+) - F104-1 (GVO+) Always Below 1 Ω
      F100-2 (GVI-) - F104-2 (GVO-) Always Below 1 Ω
      F100-3 (GVG1) - F104-3 (GVG1) Always Below 1 Ω
      F100-1 (GVI+) - Body ground Always 10 kΩ or higher
      F100-2 (GVI-) - Body ground Always 10 kΩ or higher
      F100-3 (GVG1) - Body ground Always 10 kΩ or higher

    OK

    REPLACE MULTI-DISPLAY ASSEMBLY Click here

    NG

    REPLACE HARNESS AND CONNECTOR (GVIF CABLE)