WINDOW GLASS ANTENNA WIRE REPAIR

PROCEDURE


  1. INSPECT WINDOW GLASS ANTENNA WIRE

    A01XB56E02
    *1 Tester Probe
    *2 Antenna Wire
    *3 Tin Foil

    Note

    When cleaning the glass, use a soft, dry cloth, and wipe the glass in the direction of the wire. Take care not to damage the wires. Do not use detergents or glass cleaners with abrasive ingredients. When measuring voltage, wind a piece of tin foil around the top of the probe and press the foil against the wire with your finger, as shown in the illustration.


    1. A01WZ92

      Check the voltage at the center of each wire, as shown in the illustration.

  2. REPAIR WINDOW GLASS ANTENNA WIRE

    A01XC0PE01
    *1 Repair Point
    *2 Masking Tape
    *3 Broken Wire

    1. Clean the broken wire tips with grease, wax and silicone remover.

    2. Place masking tape along both sides of the wire to be repaired.

    3. Thoroughly mix the repair agent (DuPont paste No. 4817).

    4. A01X1APE01
      *1 Fine Tip Brush
      *2 Repair Point

      Using a fine tip brush, apply a small amount of the repair agent to the wire.

    5. After a few minutes, remove the masking tape.

      Note

      Do not allow electricity to flow in the antenna wire for at least 24 hours.