MULTI-MEDIA INTERFACE ECU REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE FRONT SEAT ASSEMBLY RH (for Manual Seat)


    1. Remove the front seat assembly RH Click here.

  4. REMOVE FRONT SEAT ASSEMBLY RH (for Power Seat)


    1. Remove the front seat assembly RH Click here.

  5. REMOVE INSTRUMENT SIDE PANEL RH (w/o Airbag Cut Off Switch)

    Click here

  6. REMOVE INSTRUMENT SIDE PANEL RH (w/ Airbag Cut Off Switch)

    Click here

  7. REMOVE FRONT DOOR SCUFF PLATE RH

    Click here

  8. REMOVE COWL SIDE TRIM BOARD RH

    Click here

  9. REMOVE FRONT FLOOR CARPET ASSEMBLY


    1. Pull back the carpet far enough so that the selector can be removed. For further details, refer to the removal procedure Click here.

  10. REMOVE MULTI-MEDIA INTERFACE ECU


    1. Disconnect the connectors.

    2. A01X0PX

      Remove the 2 bolts and multi-media interface ECU.

  11. REMOVE NO. 1 MULTI-MEDIA INTERFACE BRACKET


    1. A01X3NJ

      Remove the 2 bolts and bracket.

  12. REMOVE NO. 2 MULTI-MEDIA INTERFACE BRACKET


    1. A01X3TB

      Remove the 2 bolts and bracket.