REAR SEAT ENTERTAINMENT ECU REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE FRONT SEAT ASSEMBLY RH

    for Manual Seat Click here.

    for Power Seat Click here.

  4. REMOVE INSTRUMENT SIDE PANEL RH

    Click here

  5. REMOVE FRONT DOOR SCUFF PLATE RH

    Click here

  6. REMOVE COWL SIDE TRIM BOARD RH

    Click here

  7. REMOVE FRONT FLOOR CARPET ASSEMBLY


    1. Pull back the carpet far enough so that the selector can be removed. For further details, refer to the removal procedure Click here.

  8. REMOVE MULTI-DISPLAY CONTROLLER SUB-ASSEMBLY


    1. B001VSL

      Disconnect the connectors and detach the 3 clamps.

    2. Remove the 3 bolts and multi-display controller sub-assembly.

  9. REMOVE NO. 2 MULTI-DISPLAY CONTROLLER BRACKET


    1. B001YHM

      Remove the 2 bolts and bracket.

  10. REMOVE NO. 3 MULTI-DISPLAY CONTROLLER BRACKET


    1. B001XAQ

      Remove the 2 bolts and bracket.

  11. REMOVE FRONT CONSOLE BOX

    w/o Cool Box Click here

    w/ Cool Box Click here

  12. REMOVE NO. 1 NAVIGATION WIRE


    1. Detach the clamps.

      B001XI7E03
      Text in Illustration
      *A w/ DCM(Telematics Transceiver) - -

    2. Disconnect the connector and remove the No. 1 navigation wire.