STEREO JACK ADAPTER ASSEMBLY REMOVAL

PROCEDURE

1. PRECAUTION

   Note

   After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

3. REMOVE NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION

   Click here

4. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH

   Click here

5. REMOVE NO. 1 INSTRUMENT PANEL FINISH PANEL CUSHION

   Click here

6. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH

   Click here

7. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY

   Click here

8. REMOVE LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

   Click here

9. REMOVE REAR UPPER CONSOLE PANEL SUB-ASSEMBLY

   Click here

10. REMOVE CONSOLE CUP HOLDER BOX SUB-ASSEMBLY

    Click here

11. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY

    Click here

12. REMOVE NO. 1 STEREO JACK ADAPTER ASSEMBLY

    
    

    1. 

       Detach the 2 claws and remove the stereo jack adapter.

13. REMOVE REAR CONSOLE END PANEL SUB-ASSEMBLY

    Click here

14. REMOVE HEADPHONE TERMINAL

    
    

    1. 

       Remove the 2 screws.

    2. Detach the connector clamp.

    3. 

       Detach the 4 claws and remove the terminal.