Click here

RADIO ANTENNA CORD INSTALLATION

Click here
Click here

PROCEDURE


  1. Click here

    INSTALL ANTENNA CORD SUB-ASSEMBLY (w/o Multi-display)


    1. A01WZDV

      for LHD:

      Attach the 7 clamps to install the antenna cord.

    2. A01X7PQ

      for RHD:

      Attach the 5 clamps to install the antenna cord.

  2. Click here

    INSTALL ANTENNA CORD SUB-ASSEMBLY (w/ Multi-display)


    1. A01X7ZD

      for LHD:

      Attach the 8 clamps to install the antenna cord.

    2. A01X2BA

      for RHD:

      Attach the 6 clamps to install the antenna cord.

  3. Click here

    INSTALL INSTRUMENT PANEL SAFETY PAD ASSEMBLY


    1. Install the instrument panel safety pad (Click here).

  4. Click here

    INSTALL ANTENNA CORD SUB-ASSEMBLY


    1. w/o Sliding Roof:


      1. B001WMCE01
        Table 1.
        *1 B Area
        *2 A Area
        *3 Double-sided Tape
        *4 Red Tape

        Apply new double-sided tape as shown in the illustration.

        Tip:

        Attach double-sided tape to the hatched areas shown in the illustration below.

      2. Align the red tape wound around the antenna cord with the V markings on the roof headlining and the notch at the rear of the headlining, and attach the antenna cord to the double-sided tape.

      3. Attach the 2 clamps and fit the antenna into the notch.

    2. w/ Sliding Roof:


      1. Apply new double-sided tape as shown in the illustration.

        B002002E01
        Table 2.
        *1 B Area
        *2 A Area
        *3 Double-sided Tape
        *4 Red Tape
        Tip:

        Attach double-sided tape to the hatched areas shown in the illustration below.

      2. Align the red tape wound around the antenna cord with the V markings on the roof headlining and the notch at the rear of the headlining, and attach the antenna cord to the double-sided tape.

      3. Attach the 4 clamps and fit the antenna into the notch.

  5. Click here

    INSTALL ROOF HEADLINING ASSEMBLY


    1. w/o Sliding Roof:

      Install the roof headlining (Click here).

    2. w/ Sliding Roof:

      Install the roof headlining (Click here).

  6. Click here

    CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  7. Click here

    CHECK SRS WARNING LIGHT


    1. Check the SRS warning light (Click here).