REAR DOOR SPEAKER REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedures for the LH side and RH side.

  • The procedures listed below are for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE REAR DOOR INSIDE HANDLE BEZEL LH

    Click here

  4. REMOVE REAR DOOR ARMREST BASE PANEL ASSEMBLY LH


    1. B001WAU

      Using a moulding remover, detach the 7 claws.

    2. Disconnect the connector and remove the armrest base panel.

  5. REMOVE DOOR ASSIST GRIP COVER LH

    Click here

  6. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  7. REMOVE REAR SPEAKER SET


    1. B001WOL

      Disconnect the speaker connector.

    2. Remove the 3 screws.

    3. Detach the claw and remove the speaker.

      Note

      Do not touch the cone part of the speaker.

  8. REMOVE REAR NO. 3 SPEAKER ASSEMBLY (for 14 Speakers)


    1. B001WVS

      Disconnect the connector.

    2. Detach the clamp.

    3. Remove the 2 screws and speaker.

      Note

      Do not touch the cone part of the speaker.