RADIO RECEIVER(w/o Stereo Component Amplifier) REMOVAL

Click here

PROCEDURE

1. Click here

   PRECAUTION

   Note:

   After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).

2. Click here

   DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   Note:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

3. Click here

   REMOVE NO. 1 SPEAKER OPENING COVER ASSEMBLY

   Click here

4. Click here

   REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY

   Click here

5. Click here

   REMOVE NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY

   Click here

6. Click here

   REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL CENTER

   
   
   1. 

      Detach the 10 claws on the backside of the cluster finish panel to remove it.

7. Click here

   REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET

   
   
   1. 

      Remove the 2 screws and 2 bolts.

   2. Disconnect the connectors and remove the radio receiver.

8. Click here

   REMOVE NO. 1 RADIO BRACKET

   
   
   1. 

      Remove the 3 bolts and bracket.

9. Click here

   REMOVE NO. 2 RADIO BRACKET

   
   
   1. 

      Remove the 3 bolts and bracket.

10. Click here

    REMOVE CLOCK ASSEMBLY

    Click here

11. Click here

    REMOVE HAZARD WARNING SIGNAL SWITCH ASSEMBLY

    Click here