INSTRUMENT PANEL SPEAKER INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedures for the LH side and RH side.

  • The procedures listed below are for the LH side.

  • A bolt without a torque specification is shown in the standard bolt chart Click here.

PROCEDURE


  1. INSTALL FRONT NO. 2 SPEAKER ASSEMBLY


    1. Connect the connector.

      B001W5IE01
      *1 for 9 Speakers:
      *2 for 14 Speakers:
      *3 for 4, 6 Speakers:

    2. Temporarily install the speaker by aligning the positioning pins of the speaker with the instrument panel.

    3. Install the speaker with the 2 bolts.

      Note


      • Do not touch the cone part of the speaker.

      • When installing the speaker to the instrument panel be careful that the wires do not get caught between the parts.

  2. INSTALL NO. 1 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY

    Click here

  3. INSTALL FRONT PILLAR GARNISH LH

    Click here

  4. INSTALL ASSIST GRIP SUB-ASSEMBLY

    Click here

  5. INSTALL FRONT NO. 4 SPEAKER ASSEMBLY


    1. Connect the speaker connector.

    2. Temporarily install the speaker by aligning the positioning pins of the speaker with the instrument panel.

    3. Install the speaker with the 2 bolts.

      B001Y47E01
      *1 for 9 Speakers:
      *2 for 14 Speakers:

      Note


      • Do not touch the cone part of the speaker.

      • When installing the speaker to the instrument panel be careful that the wires do not get caught between the parts.

  6. INSTALL NO. 1 SPEAKER OPENING COVER ASSEMBLY

    Click here

  7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.