REAR SEAT ENTERTAINMENT SYSTEM Visual Mute Signal Circuit between Multi-display Controller and Television Display Assembly

DESCRIPTION

This is the visual mute signal circuit between the multi-display controller sub-assembly and television display assembly.

WIRING DIAGRAM

A01X71RE12
*a Television Display Assembly RH
*b Television Display Assembly LH
*c Multi-display Controller Sub-assembly

PROCEDURE


  1. CHECK MULTI-DISPLAY CONTROLLER SUB-ASSEMBLY


    1. A01X46KE01
      Text in illustration
      *a

      Component with harness connected

      (Multi-display Controller Sub-assembly)

      Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      L68-4 (VMT1) - Body ground RSE playing → Source changed Higher than 3.5 V → Below 1 V
      L68-5 (VMT2) - Body ground RSE playing → Source changed Higher than 3.5 V → Below 1 V

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

  2. CHECK HARNESS AND CONNECTOR (MULTI-DISPLAY CONTROLLER SUB-ASSEMBLY - TELEVISION DISPLAY ASSEMBLY RH AND LH)


    1. Disconnect the L68 multi-display controller sub-assembly connector.

    2. Disconnect the c38 television display assembly RH connector.

    3. Disconnect the c43 television display assembly LH connector.

    4. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      for RH
      Tester Connection Condition Specified Condition
      L68-4 (VMT1) - c38-2 (VMTR) Always Below 1 Ω
      L68-4 (VMT1) - Body ground Always 10 kΩ or higher
      for LH
      Tester Connection Condition Specified Condition
      L68-5 (VMT2) - c43-2 (MUT1) Always Below 1 Ω
      L68-5 (VMT2) - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. CHECK MULTI-DISPLAY CONTROLLER SUB-ASSEMBLY


    1. A01WYWXE01
      Text in Illustration
      *A for RH
      *B for LH
      *a

      Front view of wire harness connector

      (to Television Display Assembly)

      Disconnect the c38 television display assembly RH connector.

    2. Disconnect the c43 television display assembly LH connector.

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      for RH
      Tester Connection Condition Specified Condition
      c38-2 (VMTR) - Body ground Display operating → Source changed Higher than 3.5 V → Below 1 V
      for LH
      Tester Connection Condition Specified Condition
      c43-2 (MUT1) - Body ground Display operating → Source changed Higher than 3.5 V → Below 1 V
      Result
      Result Proceed to
      OK (for RH) A
      OK (for LH) B
      NG C

    A

    REPLACE TELEVISION DISPLAY ASSEMBLY RH Click here

    B

    REPLACE TELEVISION DISPLAY ASSEMBLY LH Click here

    C

    REPLACE MULTI-DISPLAY CONTROLLER SUB-ASSEMBLY Click here