AUDIO AND VISUAL SYSTEM(w/ Multi-display), Diagnostic DTC:B158F

DTC Code DTC Name
B158F AV Signal Stoppage (Low Battery Voltage)

DESCRIPTION

This DTC is stored when a video or audio signal is interrupted due to battery voltage input to the multi-media module receiver assembly dropping temporarily.

DTC Code DTC Detection Condition Trouble Area
B158F A video or audio signal is interrupted when the battery voltage drops.

  • Harness or connector

  • Multi-media module receiver assembly

WIRING DIAGRAM

B001VP1E30
*1 from Battery
*2 RADIO
*3 Multi-media Module Receiver Assembly

CAUTION / NOTICE / HINT

Note

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE


  1. CHECK VEHICLE SIGNAL (OPERATION CHECK)


    1. B001Y0O

      Enter the "Vehicle Signal Check Mode" screen. [Refer to Check Vehicle Signal in Operation Check Click here]

    2. Check that the battery voltage.

      Standard voltage
      11 to 14 V

      Tech Tips

      This display is updated once per second. As a result, it is normal for the display to lag behind the actual switch operation.


    NG

    CHECK HARNESS AND CONNECTOR (MULTI-MEDIA MODULE RECEIVER ASSEMBLY - BATTERY) Click here

    OK

  2. CLEAR DTC


    1. Clear the DTCs Click here.


    NEXT

  3. CHECK FOR DTC


    1. Recheck for DTCs and check if the same DTC is output again Click here.

      OK
      No DTCs are output.

    OK

    USE SIMULATION METHOD TO CHECK Click here

    NG

    REPLACE MULTI-MEDIA MODULE RECEIVER ASSEMBLY Click here

  4. CHECK HARNESS AND CONNECTOR (MULTI-MEDIA MODULE RECEIVER ASSEMBLY - BATTERY)


    1. B001XRZE01
      Text in Illustration
      *a

      Front view of wire harness connector

      (to Multi-media Module Receiver Assembly)

      Disconnect the multi-media module receiver assembly connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      F77-17 (+B1) - Body ground Always 11 to 14 V

    OK

    REPLACE MULTI-MEDIA MODULE RECEIVER ASSEMBLY Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR