AUDIO AND VISUAL SYSTEM(w/o Navigation System) Radio Receiver Communication Error

PROCEDURE


  1. IDENTIFY COMPONENT SHOWN BY SUB-CODE


    1. Enter diagnostic mode.

      A01XC2PE26

    2. Press preset switch "2" to change the mode to "Detailed Information Mode".

    3. Identify the component shown by the sub-code.

      Tech Tips


      • "P190" set by the radio receiver assembly is shown in the preceding illustration as an example.

      • For details of the DTC display, refer to DTC Check/Clear Click here.


    NEXT

  2. CHECK COMPONENT SHOWN BY SUB-CODE


    1. Select the component shown by the sub-code.

      Component Table
      Component Proceed to
      Except radio receiver assembly A
      Radio receiver assembly (190) B

    B

    REPLACE RADIO RECEIVER ASSEMBLY Click here

    A

  3. CHECK POWER SOURCE CIRCUIT OF COMPONENT SHOWN BY SUB-CODE


    1. Inspect the power source circuit of the component shown by the sub-code.

      If the power source circuit is operating normally, proceed to the next step.

      Component Table
      Component Proceed to
      Stereo component amplifier assembly (440)

      Stereo component amplifier power source circuit Click here

      Multi-media interface ECU (388)

      Multi-media interface ECU power source circuit Click here


    NEXT

  4. INSPECT RADIO RECEIVER ASSEMBLY


    1. A01X8LNE01
      Text in Illustration
      *1

      Component without harness connected

      (Radio Receiver Assembly)
      *2

      Component without harness connected

      (Radio Receiver Assembly)

      Disconnect the F1 and F55 radio receiver assembly connectors.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      F1-5 (ATX+) - F1-15 (ATX-) Always 60 to 80 Ω
      F55-9 (TXM+) - F55-10 (TXM-) Always 60 to 80 Ω

    NG

    REPLACE RADIO RECEIVER ASSEMBLY Click here

    OK

  5. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - COMPONENT SHOWN BY SUB-CODE)

    Tech Tips


    • Start the check from the circuit that is near the component shown by the sub-code first.

    • For details of the connectors, refer to Terminals of ECU Click here.


    1. Referring to the following AVC-LAN wiring diagram, check the AVC-LAN circuit between the radio receiver assembly and component shown by the sub-code.


      1. Disconnect all connectors between the radio receiver assembly and component shown by the sub-code.

      2. Check for an open or short in the AVC-LAN circuit between the radio receiver assembly and component shown by the sub-code.

        OK
        There is no open or short circuit.
        A01X910E11

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  6. REPLACE COMPONENT SHOWN BY SUB-CODE


    1. Replace the component shown by the sub-code with a known good one and check if the same problem occurs again.

      OK
      Malfunction disappears.

    OK

    END

    NG

    REPLACE RADIO RECEIVER ASSEMBLY Click here