Click here

AUDIO AND VISUAL SYSTEM(w/o Navigation System) Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter

Click here
Click here
DTC Code DTC Name
  Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter
Click here

DESCRIPTION

The No. 1 stereo jack adapter assembly sends sound signal from an external device to the radio receiver assembly through this circuit.

The sound signal that has been sent is amplified by the stereo component amplifier assembly or radio receiver assembly, and then is sent to the speakers.

If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier assembly, radio receiver assembly or speakers.

Table 1. *a (Shielded) *b No. 1 Stereo Jack Adapter Assembly *c Radio Receiver Assembly
Click here

WIRING DIAGRAM

Click here

PROCEDURE


  1. Click here

    CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)


    1. Disconnect the m1 No. 1 stereo jack adapter assembly and F19 radio receiver assembly connectors.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      m1-8 (AUXO) - F19-19 (AUXI) Always Below 1 Ω
      m1-7 (ASGN) - F19-16 (ASGN) Always Below 1 Ω
      m1-5 (ARO) - F19-15 (ARI) Always Below 1 Ω
      m1-6 (ALO) - F19-17 (ALI) Always Below 1 Ω
      m1-9 (AGND) - F19-18 (AGND) Always Below 1 Ω
      m1-8 (AUXO) - Body ground Always 10 kΩ or higher
      m1-7 (ASGN) - Body ground Always 10 kΩ or higher
      m1-5 (ARO) - Body ground Always 10 kΩ or higher
      m1-6 (ALO) - Body ground Always 10 kΩ or higher
      m1-9 (AGND) - Body ground Always 10 kΩ or higher

    • OK

      PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

    • NG

      REPAIR OR REPLACE HARNESS OR CONNECTOR