Click here

AUDIO AND VISUAL SYSTEM(w/ Navigation System) Radio Receiver Power Source Circuit

Click here
Click here
DTC Code DTC Name
  Radio Receiver Power Source Circuit
Click here

DESCRIPTION

This circuit provides power to the multi-media module receiver assembly.

Click here

WIRING DIAGRAM

Click here

CAUTION / NOTICE / HINT

Note:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

Click here

PROCEDURE


  1. Click here

    CHECK CHECK HARNESS AND CONNECTOR (MULTI-MEDIA MODULE RECEIVER ASSEMBLY -BATTERY AND BODY GROUND)


    1. A01X2OLE01

      Disconnect the multi-media module receiver assembly connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      F77-12 (GND1) - Body ground Always Below 1 Ω

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      F77-15 (IG) - Body ground Engine switch on (IG) 11 to 14 V
      F77-16 (ACC1) - Body ground Engine switch on (ACC) 11 to 14 V
      F77-17 (+B1) - Body ground Always 11 to 14 V
      Table 1. Text in Illustration
      *a

      Front view of wire harness connector

      (to Multi-media Module Receiver Assembly)

    • OK

      PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

    • NG

      REPAIR OR REPLACE HARNESS OR CONNECTOR