AUDIO AND VISUAL SYSTEM(for Radio and Display Type) Display Signal Circuit between Radio Receiver and Stereo Jack Adapter

DESCRIPTION

The No. 1 stereo jack adapter assembly sends the display data signal of an external device to the radio and display receiver assembly through this circuit.

WIRING DIAGRAM

B001Y1HE03
*a Shielded
*b No. 1 Stereo Jack Adapter Assembly
*c Radio and Display Receiver Assembly

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)


    1. Disconnect the F124 radio and display receiver assembly connector.

    2. Disconnect the t1 No. 1 stereo jack adapter assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      F124-13 (VV+) - t1-5 (VV+) Always Below 1 Ω
      F124-14 (VV-) - t1-10 (VV-) Always Below 1 Ω
      F124-13 (VV+) - Body ground Always 10 kΩ or higher
      F124-14 (VV-) - Body ground Always 10 kΩ or higher
      F124-12 (SG) - Body ground Always 10 kΩ or higher

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR