AUDIO AND VISUAL SYSTEM(for Radio and Display Type) Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter

DESCRIPTION

The No. 1 stereo jack adapter assembly sends an external device sound signal to the radio and display receiver assembly through this circuit.

The sound signal that has been sent is amplified by the radio and display receiver assembly, and then is sent to the speakers.

If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the radio and display receiver assembly or speakers.

WIRING DIAGRAM

B001WIAE03
*1 Shielded
*2 No. 1 Stereo Jack Adapter Assembly
*3 Radio and Display Receiver Assembly

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (NO. 1 STEREO JACK ADAPTER ASSEMBLY - RADIO AND DISPLAY RECEIVER ASSEMBLY)


    1. Disconnect the t1 No. 1 stereo jack adapter assembly connector.

    2. Disconnect the F124 radio and display receiver assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      t1-7 (VAL+) - F124-28 (VAL+) Always Below 1 Ω
      t1-6 (VAR+) - F124-26 (VAR+) Always Below 1 Ω
      t1-8 (VA-) - F124-27 (VA-) Always Below 1 Ω
      t1-11 (AGND) - F124-11 (AGND) Always Below 1 Ω
      t1-9 (ADPG) - F124-25 (ADPG) Always Below 1 Ω
      t1-7 (VAL+) - Body ground Always 10 kΩ or higher
      t1-6 (VAR+) - Body ground Always 10 kΩ or higher
      t1-8 (VA-) - Body ground Always 10 kΩ or higher
      t1-11 (AGND) - Body ground Always 10 kΩ or higher
      t1-9 (ADPG) - Body ground Always 10 kΩ or higher

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR