| DTC Code | DTC Name |
|---|---|
| B15F9 | UART Communication Malfunction(for A/C) |
DESCRIPTION
The multi-media module receiver assembly and multi-display assembly are connected by the UART communication line.
When a UART communication error occurs between the multi-media module receiver assembly and multi-display assembly, these DTCs will be stored.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B15F9 | Multi-display for air conditioning switch operation signal input malfunction. |
|
WIRING DIAGRAM
| *a | UIND |
| *b | Multi-display Assembly |
| *c | Multi-media Module Receiver Assembly |
PROCEDURE
CLEAR DTC
Clear the DTCs Click here.
| NEXT |
|
CHECK DTC
Recheck for DTCs and check if the same DTC is output again Click here.
| OK |
|---|
| No DTCs are output. |
| OK |
|
USE SIMULATION METHOD TO CHECK Click here |
| NG |
|
CHECK HARNESS AND CONNECTOR (MULTI-MEDIA MODULE RECEIVER ASSEMBLY - MULTI-DISPLAY ASSEMBLY)
Disconnect the F77 multi-media module receiver assembly connector.
Disconnect the F79 multi-display assembly connector.
Measure the resistance according to the value(s) in the table below.
| Standard Resistance | |||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
| NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR |
| OK |
|
REPLACE MULTI-DISPLAY ASSEMBLY
Replace the multi-display assembly with a new or normally functioning one Click here.
| NEXT |
|
CLEAR DTC
Clear the DTCs Click here.
| NEXT |
|
CHECK DTC
Recheck for DTCs and check if the same DTC is output again Click here.
| OK |
|---|
| No DTCs are output. |
| OK |
|
END (MULTI-DISPLAY ASSEMBLY IS DEFECTIVE) |
| NG |
|
REPLACE MULTI-MEDIA MODULE RECEIVER ASSEMBLY Click here |