STEERING CONTROL ECU(for RHD) INSTALLATION

PROCEDURE

1. INSTALL STEERING CONTROL ECU

   
   

   1. Install the steering control ECU to the junction block with the claw and bolt.

      Torque:

      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

2. INSTALL STEERING CONTROL ECU WITH JUNCTION BLOCK

   
   

   1. Install the junction block with the bolt and 2 nuts.

      Torque:

      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

3. INSTALL NO. 1 SWITCH HOLE BASE

   Click here

4. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY (w/o Driver Side Knee Airbag)

   Click here

5. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY (w/ Driver Side Knee Airbag)

   Click here

6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

7. VARIABLE GEAR RATIO STEERING SYSTEM CALIBRATION

   Click here