STEERING CONTROL ECU(for RHD) REMOVAL

PROCEDURE


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note


    • After the engine switch is turned off, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the engine switch off, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Driver Side Knee Airbag)

    Click here

  3. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY (w/o Driver Side Knee Airbag)

    Click here

  4. REMOVE NO. 1 SWITCH HOLE BASE

    Click here

  5. REMOVE STEERING CONTROL ECU


    1. Remove the bolt and 2 nuts.

      B001YLN

    2. Disconnect the connectors from the junction block.

    3. B001XKC

      Remove the bolt, detach the claw and remove steering control ECU from the junction block.